Use This Method To Change A Honda Civic Factory Stereo
It is easy to buy a car than maintaining it .Most of them face bitter situation when they face some problem in their car this is due to lack of knowledge about their car. It is recommended for all to know about their vehicles once they buy it. How can they know it the one and only answer all know is to search in internet .But there are few other options like enquiring from the experienced person’s .Likewise this article will be very much helpful in knowing what you searched to know that is How to remove a Honda civic radio?
For removing the radio from the Civics’ complex dash assembly you will require pliers, Philips head screw driver, an 8 mm socket wrench and gloves.
First and fore most things that everyone should know is to switch of your car when you attempt to remove something from your car that has connections. Especially that which is connected to battery. All radios run with a battery power. So it is necessary to turn your car off before you remove your radio system. Check out simultaneously whether the brakes that you have in your car for parking is been set. Using the pliers the negative terminal which would be connected in the radio should be disconnected.
The ignition engine of the civic car is turned off first. Hand brake or parking brake is applied. Hand brake is the other name for parking brake. Negative cable in your car’s battery is disconnected using the pliers. Identify the panel which is present below the car’s steering wheel. This trim panel is then pulled carefully. Trim panel gets extended till the dash board’s edge.
You can see screws holding the radio. Undo the screws with appropriate screw driver. The cluster hood is identified and it is lifted away from the car’s dash board. Place the cluster hood away from the dash board. The tiny panel which is present in between the air conditioner controllers and the radio is identified and pulled away. Two eight mm bolts are removed using the socket wrench that you have.
You can see panel which will be present beneath any radio. You should remove that panel that is small very carefully so that it is not damaged. Same type of arrangement can be seen beneath the control panel. A bolt of size 0.8cm can be seen when you look after panel behind. The control panel and d the radio that you going to remove were mounted by those bolts.
The panel is turned such a way that its backside is visible. You will find eleven screws holding air conditioner controls and the light connections to the civic car’s radio. These screws are removed using the Phillips screw driver carefully by turning the screws to their left. At last the radio is removed from the civic car’s panel.
By this time there should be no doubt in removing the radio from your car and you can now answer to the question How to remove a Honda civic radio?
Learn more about Auto. Stop by Author Name’s site where you can find out all about Car stereo and what it can do for you.